A Simple Generator Setup for Home Back-up Use

MEP-003A-Generator-Mounted-On-Concrete-Sonotubes-With-Aux-Tank

This is a great example of a MEP003A installed for home use.  The unit is place on high ground that will drain well.  Then the entire area is covered with crushed stone to aid in water transport and to minimize mud kicking up on the unit.  4 modest sono-tubes are sunk in the ground to provide ballast and stabilization to minimize vibration of the genset.  One large bolt is then set with epoxy into the concrete sonotube and then bolted to the aluminum skid that the genset is mounted on. This makes for an extremely solid, secure and tamper-proof unit.

If you want to move it, simply undo 4 bolts and place in trailer or pickup! Pretty easy.

As for fuel, this unit has the standard 12.5 gallon day tank that is fed with the on-board standard auxiliary pump that is connected to an old truck tank.  This fuel line could also directly tie into your home heating oil supply if your home or business runs on home heating oil.

2 thoughts on “A Simple Generator Setup for Home Back-up Use

  1. GMG says:

    Your question is a bit unclear. If you have 120v at the convenience outlet, but no power on the lugs, you need to make sure the main breaker is ON. If it’s on and still no power, it could be multiple issues. Make sure your phase selector switch is matched to your meter display setting. Or use a multimeter, which is always a good call.

  2. larrygmoore1 says:

    I have an MEP003A that produces no single phase on the lugs are the convenience plug but it produces three phase power on both. Please help!

Leave a Reply